Wasp WLS9500 Manuel d'utilisateur télécharger pdf (Page 49)

Keyboard Wedge Interface 5-3

Introduction

This chapter describes how to set up a Keyboard Wedge interface with the scanner. With this interface, the scanner is

connected between the keyboard and host computer, and translates bar code data into keystrokes. The host computer

accepts the keystrokes as if they originated from the keyboard. This mode adds bar code reading functionality to a system

designed for manual keyboard input. Keyboard keystrokes are simply passed through.

Throughout the programming bar code menus, default values are indicated with asterisks (

*).

Connecting a Keyboard Wedge Interface

Figure 5-1. Keyboard Wedge Connection with Y-cable

To connect the Keyboard Wedge interface Y-cable:

Interface cables vary depending on configuration. The connectors illustrated in Figure 5-1 are

examples only. The connectors may be different than those illustrated, but the steps to connect the

scanner remain the same.

1. Turn off the host and unplug the keyboard connector.

2. Attach the modular connector of the Y-cable to the cable interface port on the scanner. (See Installing the

Interface Cable on page 1-4.)

3. Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.

4. Connect the round female DIN keyboard connector of the Y-cable to the keyboard connector.

5. If needed, attach the optional power supply to the connector in the middle of the Y-cable.

6. Ensure that all connections are secure.

7. Turn on the host system.

8. Select the Keyboard Wedge host type by scanning the appropriate bar code from Keyboard Wedge Host

Parameters on page 5-5.

*North American

Feature/Option

* Indicates Default

Male DIN Connector

Female DIN

Keyboard

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 188 189

Pas de commentaire

Wasp WLS9500 Manuel d'utilisateur Page 49