Wasp WPL205 Manuel d'utilisateur télécharger pdf (Page 26)

Gap Sensor Calibration

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED turns red/amber after 5 green/amber

blinks. (Any red/amber will do during the 5 blinks).

 The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks) 

green/amber (5 blinks)  red/amber (5 blinks)  solid green

Skip AUTO.BAS

1. Turn off printer power.

2. Press the FEED button and then turn on power.

3. Release the FEED button when LED becomes solid green.

 The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks) 

green/amber (5 blinks)  red/amber (5 blinks)  solid green

4. Printer will be interrupted to run the AUTO.BAS program.

1 2 ... 21 22 23 24 25 26

Pas de commentaire

Wasp WPL205 Manuel d'utilisateur Page 26